Cardinal Gates Safety Gate MG25 User Manual

MG25 DuraGate

FOR OPENINGS 26.5” (67cm) - 41.5” (105cm) • Average installed height 29.5” (75cm)

ASSEMBLY INSTRUCTIONS

OPTION

ONE-WAY

STOP BRACKET

C or D

3. Loosen width adjustment

set screws at top and

bottom of gate with allen

wrench (F) slightly to

allow gate to expand.

Keep plastic shipping

tabs in place.

CARDINAL GATES

1 ”

2. Level gate by

adjusting

telescoping tube

attached to upper

gate with allen

wrench (F).

1. Place gate on top of carton to establish height.

Use short screws (C) for doorframes or longer

screws (D) into drywall to reach a stud.

C or D

5. Separate bracket from rod and mount as marked.

FOR ONE-WAY OPERATION: Read STEP SEVEN

and install safety bracket on bottom hole.

4. Attach latch bracket (A) to latch rod with

bracket snug against bottom of eye bolt.

Expand gate so that latch bracket (A) is against

mounting surface. Mark holes.

OPTION

STOP BRACKET

ONE-WAY

6. Use Allen wrench (F) to tighten adjustment set

7. Install one-way stop bracket (B) on one side of

latch if you wish to have gate open in only one

direction.

screws after removing plastic shipping tabs.

GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.