Casio Watch TSQ 1200 User Manual

MA0310-EA  
Operation Guide TSQ-1200  
SETTING THE TIME  
1. Remove the batteries to stop the Second hand (3) at 12 o’clock position.  
2. Rotate the Time setting dial (6) to change the time setting.  
Note that this clock does not distinguish between AM and PM times.  
3. Replace the batteries at a time signal to restart the Second hand (3) on the correct second.  
The start of Second hand (3) may be delayed depending on when you load the batteries.  
USING THE ALARM  
When the alarm is turned on, the alarm sounds for 40 minutes at the preset time each day. Once the alarm starts  
to sound, you can switch it off by pressing the Alarm ON/OFF switch (8).  
Setting the Alarm Time  
1. Rotate the Alarm setting dial (7) in the direction indicated by the arrow marked on clock to move the Alarm  
hand (4) to the alarm time setting you want.  
2. Raise the Alarm ON/OFF switch (8) to turn on the alarm.  
Note that this clock does not distinguish between AM and PM times. If you set an alarm to wake up to in the  
morning, the alarm will sound again at the same time in the evening if you leave the Alarm ON/OFF switch (8)  
raised.  
Stopping the Alarm  
To stop the alarm after it starts to sound, press the Alarm ON/OFF switch (8).  
About the alarm sound  
This clock lets you select either a standard beeper tone or bird calls as the alarm sound. When you select  
birdcalls, an alarm operation produces one of 7 different birdcalls, changing automatically to a different one with  
each alarm operation.  
The alarm sounds for about 90 seconds or until you stop it. When bird call is selected with the Tone selector (5),  
the first 40 seconds uses a bird call, while the final 50 seconds the alarm sound is an electronic beeper.  
BATTERY REPLACEMENT  
Low battery power is indicated when timekeeping slows or stops completely. Should either of these symptoms  
occur, replace the batteries immediately. Do not leave low or dead batteries in the clock.  
1. Open the Back cover (9) as shown in the illustration.  
2. Remove all of the old batteries.  
3. Load a full set of new batteries. Make sure that their positive (+) and negative (–) ends face in the correct  
directions. If you load batteries incorrectly, they can burst and damage the clock.  
4. Press the RESET button (;). Be sure to press the RESET button (;) after replacing batteries.  
5. Replace the Back cover (9).  
A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the  
Battery precautions  
clock.  
Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician  
Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the  
illustration.  
immediately.  
Be sure to load the batteries with their positive (+) and negative (–) ends facing correctly.  
Never mix old and new batteries, or batteries of different brands.  
Never charge the batteries that come with the clock.  
GENERAL GUIDE  
Should batteries ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get onto  
your skin.  
1Hour hand  
Replace the batteries at least once a year, even if the current batteries are working properly.  
The batteries that come with the clock lose some of their power during transport and storage.  
2Minutes hand  
3Second hand  
4Alarm hand  
5Tone selector (Select beeper or bird call)  
6Time setting dial  
7Alarm setting dial  
8Alarm ON/OFF switch  
9Back cover  
;RESET button  
AClock battery  
BBird call batteries  
1
 

Belkin Network Card 0 00019 F5L043 User Manual
Black Box Modem Fiber Optic Modem User Manual
Black Decker Iron F920C User Manual
Bogen Speaker System ALA 5 User Manual
Braun Electric Shaver 370cc User Manual
Braun Hair Dryer SPI C 2000 DF User Manual
Briggs Stratton Lawn Mower Series 21B900 User Manual
Briggs Stratton Portable Generator 206484GS User Manual
Canon Cell Phone 3920 User Manual
Carrier Computer Hardware 38EV024320 User Manual